Since MicroFreak has had the wavetables for a long time, this update was up in the air. Lastly, you can set the clock and the transport sends on/off-two useful improvements.Īrturia took over a year to release the first major update for MiniFreak. The new firmware also ships with 64 all-new patches showcasing the new features.įor MiniFreak hardware users, there is also a new handy favorite panel for quickly accessing favorite presets. These are available for both the hardware and software versions. Plus, you can buy two new commercial banks of 64 patches. It ships with three free banks of 32 patches at launch, with more to come. It’s not a new feature of the hardware, but the MiniFreak V now ships with a sound store where you can buy and download new sounds. With this, you can create custom LFO shapes that run fast. You can now set the LFO rate either to a single step or the entire shaper length. You can control it with three parameters: detune, LP/HP filtering, and dry/wet mix. It also has interesting sub-types, including free-running chorus effects. It’s a chorus-type effect, with up to 6 copies stacked on top of the dry signal, allowing it to create a very wide, fat sound. Super UnisonĪnother major new feature is a new super unison FX. Arturia says that the oscillators are capable of phase reset on new voices triggered, and, therefore, they should also respond to this new feature. Then, the oscillator algorithm from Noise Engineering gets a new OSC freerun functionality. So far, no custom wavetable import function is available I hope this will be added in the future. Unlike the hardware, the plugin gives a visualized wavetable and instant feedback on what happens to it when you shape it with the parameters. Of course, users of the MiniFreak V also benefit from the new wavetable engine. Timbre adjusts the symmetrical pulse width and shape is a 1-pole lowpass/highpass filter. With shift and type, you can browse through the 32 factory wavetables. The wave knob scans through the selected wavetable. Once loaded, you can tweak the engine with three parameters. So you can’t create a super 2-oscillator wavetable synth. A downer: the wavetable engine is only available for the oscillator 1 slot, not on both. The big highlight of firmware 2.0 is the introduction of a long-awaited wavetable synth engine, previously only available in the MicroFreak.Īccording to Arturia, it’s an improved version with more fidelity to the original wavetable, higher frequency range, and less noise/aliasing than the engine in the MicroFreak. Both versions receive the same features with this update expect some minor menu operation changes. MiniFreak 2.0 is a new free firmware update for the hardware and software version of Arturia’s hybrid polyphonic synth. But I have good news: Arturia has just dropped a new MiniFreak firmware 2.0 with major new features. Things have been quiet since the hardware was released last year. The MiniFreak V, a virtual version, followed in January. Arturia responded to this big request with the MiniFreak release in October 2022-a 6-voice poly version of the MicroFreak. The call for a poly version came quickly. The MicroFreak is already a modern classic after just a few years on the market-a mega success for Arturia. Arturia has released the MiniFreak 2.0 firmware that adds the mighty wavetable engine to the oscillators, a new super unison FX, and more.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |